Product Description

VALVE SERVICE PAINT is made up of synthetic resin, aluminum dust, anti-corrosive pigment, chromatic pigment and constitutional pigment by abrading and adding variety of auxiliary agent and organic solvent, which including IRON RED VALVE SERVICE PRIMER and ALUMINUM VALVE TOPCOAT.

Intended uses

Mainly used for coating the surface of valves, as well as other metallic structures.

Service Temperature

Maximum service temperature is up to 150 ℃ in dry condition.

Coating Data

PRIMER:

Colour: Iron Red

Volume Solids: ≥ 50%

Dry (25 ℃ ): Touch dry ≤ 0.5 h, Hard dry ≤ 24 h; Fully cured 5 d.

TOPCOAT:

Colour: Aluminum

Volume Solids: ≥ 40%

Dry (25 ℃ ): Touch dry ≤ 0.5 h, Hard dry ≤ 24 h; Fully cured 5 d.

Application Details

Application Method: Air spray, brush, roller; The best paint application method is spraying.

Before application of topcoat, coated primer should be unaffectedly airing for 2 hours or roasting for half a hour.

Surface Preparation

1. All metallic surface to be coated for the first time should be cleaned and free from contamination such as grease, inorganic salt, duct and so on. May perform the distinguish and treatment according to the standard ISO8504-1:1992.

2. Any surface with old paint should be cleaned and free from contamination such as grease., dust and water. And then be partially repaired. May perform the distinguish and treatment according to the standard ISO8504-1:1992

3. Areas of breakdown, damage etc., should be prepared to the specified standard (e.g. Sa2-1/2 --- ISO8501-1:1988).

4. Before application of this topcoat, the surface to be coated should have existed primer, both alkyd primer or epoxy primer can be utilized.

Application Precautions

1. Prior to application, this material should be thoroughly agitating for free of deposition occurred during storage.

2. End application, thoroughly flush all equipment with thinner.

3. All surface to be coated should be clean and dry. Surface temperature must always be a minimum of 3 ℃ above dew point. Consequently keep away from condensation which will be affected to the film adhesion performance, glossy and colour of coatings.

4. As this product contains the V.O.C. solvent, in confined spaces must provide adequate ventilation during application and drying.

Storage

Storage Condition: Store in dry, shaded condition away from shining and heat source.

Shelf Life: 12 months minimum at 25 ℃ . As to those paint, which is over than shelf life but is inspected well just then, is permitted to be still in the use.

 

SUZHOU COLOURWAY ENTERPRISE DEVELOPMENT CO., LTD

ADD: SHENJIA ROAD , DONGQIAO INDUSTRY DEVELOPING ZONE, XIANGCHENG DISTRICT, SUZHOU

PHONE: 0512-65376968

FAX: 0512-65376978

ZIP: 215152