Product Description

H06-18 EPOXY ON-RUST PRIMER is a single component, airing dry product, which has excellent performance of anti-corrosion and firm adhesion with both substrate and topcoat. Its main gradients: iron oxide epoxy ester and special anti-corrosive pigment.

Intended uses

Suitable for priming on the surface of steel structures including vehicles, ships, machinery, bridges, chemical equipment, elevators, etc., compatible with all kinds of topcoats, e.g. alkyd, amino, polyurethane, nitrocellulose, acrylic etc.

Service Temperature

Maximum service temperature is up to 120 ℃ in dry condition.

Coating Data

Colour: wild range

Gloss level: Semi-gloss or matt

Dry (25 ℃ ): Touch dry ≤ 1 h, Hard dry ≤ 48 h

Volume Solids: ≥ 70%

V.O.C.: 300 g / litre

Specific Gravity: 1.3 kg / litre

Flash Point: 25 ℃

Application Details

Application Method: Airless spray, Air spray, brush, roller.

System Compatibility: See also the alkyd, amino, polyurethane, nitrocellulose topcoats listed in COLOUR-WAY products catalogue.

Surface Preparation

1. All metallic surface to be coated for the first time should be cleaned and free from contamination such as grease, inorganic salt, duct and so on. May perform the distinguish and treatment in accordance with the standard ISO8504-1:1992.

2. Any surface with old paint should be cleaned and free from contamination such as grease., dust and water. And then be partially repaired. May perform the distinguish and treatment in accordance with the standard ISO8504-1:1992

3. Areas of breakdown, damage etc., should be prepared to the specified standard (e.g. Sa2-1/2 --- ISO8501-1:1988).

Application Precautions

1. Prior to application, this material should be thoroughly agitating and adjusting to appropriate adhesion by thinner.

2. No touch with such materials, e.g. water, oil, acid, alkali and so on during application.

3. No fire and good ventilation in application site.

4. To prevent from surface curding, a little terebinth and #200 solvent oil might be covering on the surface of residual paint.

5. In case of thicker film, overcoating time for time is necessary, 20 microns dry ( 30 microns wet ) each time. Before overcoating, the former layer should be thoroughly dry.

Storage

Storage Condition: Store in dry, shaded condition away from shining and heat source.

Shelf Life: 12 months minimum at 25 ℃ . As to those paint, which is over than shelf life but is inspected well just then, is permitted to be still in the use.

 

SUZHOU COLOURWAY ENTERPRISE DEVELOPMENT CO., LTD

ADD: SHENJIA ROAD , DONGQIAO INDUSTRY DEVELOPING ZONE, XIANGCHENG DISTRICT, SUZHOU

PHONE: 0512-65376968

FAX: 0512-65376978

ZIP: 215152