Product Description

ACRYLIC CHLORINATED PVC ENAMEL is a single component, glossy finish coating, which has excellent performance of climate-resistance and anti-corrosion, as well as good gloss and colour retaining in outdoor.

Intended uses

Mainly used for topcoat, compatible with other primers for external use. Suitable for the anti-corrosion of kinds of steel structures in moderately corrosive environment including chemical industrial pipes, indoor or outdoor steel structures, external wall of storage tanks, as well as used for anti-corrosive wall coating in workshop and coating on the surface of machinery.

Service Temperature

Maximum service temperature is up to 60 ℃ in dry condition.

Coating Data

Colour: wild range

Gloss level: Glossy

Volume Solids: ≥ 70%

Typical Thickness: 21 macrons ( dry film)

Dry (25 ℃ ): Touch dry ≤ 20 min, Hard dry ≤ 90min

Theoretical Coverage: 5 ~ 7 m2 / kg (21 macrons )

Application Details

Application Method: Air spray (Mainly recommended )

Air pressure: 30 kg / cm2 or around

Mixed Solvent Ratio: 1 : 1.5 ~2.0

Thinner: X –3 CHLORINATED PVC THINNER

Cleaner: X –3 CHLORINATED PVC THINNER

Surface Preparation

1. All metallic surface to be coated for the first time should be cleaned and free from contamination such as grease, inorganic salt, duct and so on. May perform the distinguish and treatment in accordance with the standard ISO8504-1:1992.

2. Any surface with old paint should be cleaned and free from contamination such as grease., dust and water. And then be partially repaired. May perform the distinguish and treatment in accordance with the standard ISO8504-1:1992

3. Areas of breakdown, damage etc., should be prepared to the specified standard (e.g. Sa2-1/2 --- ISO8501-1:1988).

4. Before application of this topcoat, the surface to be coated should be have existed primer, both alkyd primer or epoxy primer can be utilized.

Application Precautions

1. Prior to application, stir this material thoroughly to a uniform consistency. Filter coarse grains and impurities by means of eye 120 mesh.

2. If in wet weather,

3. No fire and good ventilation in application site.

4. To prevent from surface curding, a little terebinth and #200 solvent oil might be covering on the surface of residual paint.

5. In case of thicker film, overcoating time for time is necessary, 20 microns dry ( 30 microns wet ) each time. Before overcoating, the former layer should be thoroughly dry.

Storage

Storage Condition: Store in dry, shaded condition away from shining and heat source.

Shelf Life: 12 months minimum at 25 ℃ . As to those paint, which is over than shelf life but is inspected well just then, is permitted to be still in the use.

 

SUZHOU COLOURWAY ENTERPRISE DEVELOPMENT CO., LTD

ADD: SHENJIA ROAD , DONGQIAO INDUSTRY DEVELOPING ZONE, XIANGCHENG DISTRICT, SUZHOU

PHONE: 0512-65376968

FAX: 0512-65376978

ZIP: 215152